The store will not work correctly when cookies are disabled.
Nous utilisons les cookies pour vous offrir une meilleure expérience utilisateur.Pour se conformer à la nouvelle directive concernant la vie privée, nous devons vous demander votre consentement pour sauvegarder des cookies sur votre ordinateur. En savoir plus.
2011 to 2014 Honda CR-Z with K&N Air Intake Cranks Up Power and Performance
2011 to 2014 Honda CR-Z with K&N Air Intake Cranks Up Power and Performance
9 août 2011
K&N Air Intake Installed on 2011 Honda CR-Z 1.5L
Dyno Chart for 2011 Honda CR-Z 1.5L
By unveiling of a new sport hybrid coupe for the North American market,
Honda blurred the lines between performance and environmental responsibility with the 2011 to 2014 Honda CR-Z. Complete with a 1.5L i-VTEC engine and Integrated Motor Assist (IMA) hybrid-electric system, this uniquely designed hybrid is geared for the driver looking for a way to both protect the environment and have a little fun on the road.
K&N Air Intake System for 2011 to 2014 Honda CR-Z 1.5L
K&N shares these same ideals by offering washable and reusable high flow air filters and intake systems that cut down on disposable filter waste while adding power and performance. The new 69-1018TS Typhoon Air Intake System does just that for the 2011 to 2014 Honda CR-Z. The 69-1018TS
intake comes complete with a free-flowing mandrel-bent aluminum tube and oversized high flow X-Stream top
air filter, all in a ready to install bolt-on system for your CR-Z.
"The 2011 Honda CR-Z is a new vehicle platform and required new development of major kit components," says K&N Performance Kit Manager Bert Heck. "A new intake tube was developed for the 69-1018TS utilizing a reduced volume area in the mass air sensor location to retain factory drivability while increasing horsepower." Heck also reported the development of a new heat shield and mounting brackets to protect the air filter from direct-radiated heat and to provide a durable mounting location for the intake tube and air filter assembly. Heck and the K&N intake development team utilized the factory lower fresh air duct and airbox mounting locations. Over 160 dyno runs and many miles of on-road testing went into the development of the 69-1018TS to verify the great performance differences that this intake kit can make.
The estimated power gain of the
69-1018TS
when installed on a 2011 Honda CR-Z with a 1.5 liter engine is 4.7 horsepower at 5049 rpm.
This single upgrade to the 69-1018TS
replaces the factory airbox and is guaranteed to add horsepower and torque to your CR-Z, while providing easier airflow and excellent filtration to protect your engine. The 69-1018TS is equipped with
a K&N X-Stream top air filter, part RX-4950,
which is designed with K&N's multi-layered oiled cotton gauze media and will
only require servicing up to every 50,000 miles depending on driving conditions. The 69-1018TS is also backed with an industry leading 1,000,000 mile limited lifetime warranty
for peace of mind, while you and your CR-Z are protecting the environment from waste and boredom.
The K&N air intake 69-1018TS fits the following Hondas:
2016 HONDA CR-Z 1.5L L4
2015 HONDA CR-Z 1.5L L4
2014 HONDA CR-Z 1.5L L4
2013 HONDA CR-Z 1.5L L4
2012 HONDA CR-Z 1.5L L4
2011 HONDA CR-Z 1.5L L4
